Solution 1:
- Look inside for a tiny object like a piece of paper, a staple...
Solution 2:
- There is a thin plastic strip running across the width in front of and below the drive belt: there are fine black vertical lines on this strip.
- If the strip gets a piece of crud on it, you get an error during the start-up sequence.
- Gently clean this strip with a damp lint-free tissue.
Solution 3:
- The purge cap (the white sliding mechanism that the print head parks to when it's not in use) may be not lubricated well enough.
- Lubricate the sliders with some white grease (don't get it on the small wipers or the black caps).
- This repair probably require to remove the right panel off of the printer to gain access to the purge mechanism.
Download Full.zip |
Download Full .rar |
Download Full .iso |
0 nhận xét :